13-06-2013, 09:30 AM
Mine arrived a few days ago. I think I messed up my order - got the one without the backlight. Still, it works just fine.
Anyone have ideas on a good case for it? The fact that it's a split level two board layout makes it a bit tricky to find a case that will take it as-is. Separating the two boards then gets us into ribbon cables between the boards, etc.
As Yorkie mentioned, there is not a lot of room for soldering on this thing - the pads are very small.
I did some comparison measurements on inductance with my Peak LCR40 - will post some photos later.
Cheers, John
Anyone have ideas on a good case for it? The fact that it's a split level two board layout makes it a bit tricky to find a case that will take it as-is. Separating the two boards then gets us into ribbon cables between the boards, etc.
As Yorkie mentioned, there is not a lot of room for soldering on this thing - the pads are very small.
I did some comparison measurements on inductance with my Peak LCR40 - will post some photos later.
Cheers, John
Time flies like an arrow, fruitflies like a banana!
