Hi,
C'mon Big Al I did say I would add dimensions later once I had made the clutch and tested it in post #65? Until I have a working clutch this is only an idea so far and it might not even work because I've never seen this tried before.
The drawing is only in 2D so it won't open in 3D but I've just sent you more details Alan via email together with the rough 3D drawings you can rotate in 3D.
When I stated a scaled drawing it is certainly better scaled than drawing using a pencil onto a piece of scrap paper and apart from the bearing sizes the other sizes are not critical and again I've already added the two bearing sizes?
All I need now is some warm weather to allow me into the garage to play on the lathe in comfort; perhaps I should move in with you Colin or Lawrence until this project is completed because it keeps snowing here?
Kind regards, Col.
C'mon Big Al I did say I would add dimensions later once I had made the clutch and tested it in post #65? Until I have a working clutch this is only an idea so far and it might not even work because I've never seen this tried before.
The drawing is only in 2D so it won't open in 3D but I've just sent you more details Alan via email together with the rough 3D drawings you can rotate in 3D.
When I stated a scaled drawing it is certainly better scaled than drawing using a pencil onto a piece of scrap paper and apart from the bearing sizes the other sizes are not critical and again I've already added the two bearing sizes?
All I need now is some warm weather to allow me into the garage to play on the lathe in comfort; perhaps I should move in with you Colin or Lawrence until this project is completed because it keeps snowing here?
Kind regards, Col.
Happiness is a wreck of a cabinet to restore.
