11-04-2011, 05:00 PM
You might get more clues here.
http://www.palsite.com/slc20tech.html
Check for broken gears, dust, muck and any belts. These are the causes of most problems with any VCR deck. Also check that the 4.43 Mhz colour sub-carrier reference in the servo circuit. This in turn is normally caused by failure of silicon fuse PS1 on the YC-25 board.
Good luck!
Cheers,
Steve P.
http://www.palsite.com/slc20tech.html
Check for broken gears, dust, muck and any belts. These are the causes of most problems with any VCR deck. Also check that the 4.43 Mhz colour sub-carrier reference in the servo circuit. This in turn is normally caused by failure of silicon fuse PS1 on the YC-25 board.
Good luck!
Cheers,
Steve P.
If we've always had that, why is the car boot open? You aren't smuggling in another old TV are you...?
