19-02-2013, 02:40 PM
How about a 13A (not) plug that to make sure it goes bang correctly is non fused?
I tested it with the low ohms range on my PAT tester.
The terminal block came rolling in at 0.01 ohms.
The horror mains lead measured 1 whole ohm on all conductors and being marked 10 amps the cable would have been heated at 200W
The pointer is struggling to get away from the rest position.
The conductors are very thin and the cable is marked 0.5mm however the conductors measured up below this figure.
Is this one dodgy enough to get a prize?
I tested it with the low ohms range on my PAT tester.
The terminal block came rolling in at 0.01 ohms.
The horror mains lead measured 1 whole ohm on all conductors and being marked 10 amps the cable would have been heated at 200W
The pointer is struggling to get away from the rest position.
The conductors are very thin and the cable is marked 0.5mm however the conductors measured up below this figure.
Is this one dodgy enough to get a prize?
