05-12-2012, 02:01 PM
Robin,
It depends how thin it is.
Small (thin) rods, low current and tack it first , then weld it in short runs to avoid banging holes in it. It's generally a lot easier with a MIG.
An automatic helmet makes it a lot easier to see what you're doing.
Alan
It depends how thin it is.
Small (thin) rods, low current and tack it first , then weld it in short runs to avoid banging holes in it. It's generally a lot easier with a MIG.
An automatic helmet makes it a lot easier to see what you're doing.
Alan
