20-11-2012, 09:47 PM
WOW, thanks for the response everyone, seems I will not be stuck for advice on this.
So to start with, first job will be that cap that feeds the control grid of the A.F. on the output valve, secondly will be the cap that feeds the tone control.
I think my biggest problem will be the noise limiter, as soon as it is switched to MAN. N.L. or A.V.C. N.L. the sound dies, the noise limiter control next to the signal meter does not make any difference, the receiver stays quiet with the control operated end to end.
As to the glass dial panel, I wonder if a good dial scan transferred to glass would look OK, must admit I have never seen it done on one of these.
I will also replace the bathtubs, I am not too worried about originality, so will just replace them rather than restuffing which seems quite a dirty task.
This is the first stage that I will tackle.
(now shall I ask Santa for a Triple Diversity Rack for Christmas?)
So to start with, first job will be that cap that feeds the control grid of the A.F. on the output valve, secondly will be the cap that feeds the tone control.
I think my biggest problem will be the noise limiter, as soon as it is switched to MAN. N.L. or A.V.C. N.L. the sound dies, the noise limiter control next to the signal meter does not make any difference, the receiver stays quiet with the control operated end to end.
As to the glass dial panel, I wonder if a good dial scan transferred to glass would look OK, must admit I have never seen it done on one of these.
I will also replace the bathtubs, I am not too worried about originality, so will just replace them rather than restuffing which seems quite a dirty task.
This is the first stage that I will tackle.
(now shall I ask Santa for a Triple Diversity Rack for Christmas?)
