21-08-2012, 06:30 PM
Hi,
Exemplary work as usual from you David; the front panel does it justice as does all the neat work; very well done.
I too struggle a great deal with "CAD" This afternoon I needed to draw an accurate grid so loaded the Turbocad. It took two hours of frustration to complete the grid which no doubt Big Al with his Autocad could have knocked out in a couple of minutes. Just setting the page size is a nightmare on CAD programs so I skipped this part and simply rubber stamped a few copies of the grid and obtained what I wanted. The grid is for a drilling guide and the hole centres are where the lines cross.
Kind regards, Col.
Grid drawn by a novice using Turbocad.
Exemplary work as usual from you David; the front panel does it justice as does all the neat work; very well done.
I too struggle a great deal with "CAD" This afternoon I needed to draw an accurate grid so loaded the Turbocad. It took two hours of frustration to complete the grid which no doubt Big Al with his Autocad could have knocked out in a couple of minutes. Just setting the page size is a nightmare on CAD programs so I skipped this part and simply rubber stamped a few copies of the grid and obtained what I wanted. The grid is for a drilling guide and the hole centres are where the lines cross.
Kind regards, Col.
Grid drawn by a novice using Turbocad.
Happiness is a wreck of a cabinet to restore.
