05-03-2012, 12:27 AM
(This post was last modified: 05-03-2012, 03:11 PM by Robert Darwent.)
Appreciate your very kind comments Mark, thank you!
I would be more than happy to provide the computer program I wrote. However, it wouldn't be of much use to anyone I'm afraid.
This is because it is specific to an Ekco A22T, using the frequencies from the dial and the corresponding capacitance readings. In fact, its actually four separate programs each one tailored for each of the four coils I needed to make.
Unfortunately, the program is of no use in a general way for calculating other coils needed in different makes/models of radio. Remember, I needed to do the calculations in 'reverse', as it were, to match the existing dial.
Hope that explanation makes things a bit clearer.
Regards
I would be more than happy to provide the computer program I wrote. However, it wouldn't be of much use to anyone I'm afraid.
This is because it is specific to an Ekco A22T, using the frequencies from the dial and the corresponding capacitance readings. In fact, its actually four separate programs each one tailored for each of the four coils I needed to make.
Unfortunately, the program is of no use in a general way for calculating other coils needed in different makes/models of radio. Remember, I needed to do the calculations in 'reverse', as it were, to match the existing dial.
Hope that explanation makes things a bit clearer.
Regards
