29-12-2011, 05:21 PM
(27-12-2011, 10:20 PM)Skywave Wrote:(27-12-2011, 07:10 PM)Bushbaby Wrote: Would I be able to connect both secondaries for 240v and then operate one set of secondaries for 110v ??
Rob
Yes; as per the drawing below:
Note that the dots on the two secondary windings denote that these two ends are in phase.
Al.
Al Sorry to throw a spanner in the works but technically as you have drawn the circuit you could run just under 600watts without blowing fuses , the transformer is rated at 500 watts.That transformer could get very hot at full output on the 240v and 110v at the sametime.
Personally I would just use as two seperate secondaries ( or parallel them) or one single 240 volt secondary
Mike
