11-11-2011, 09:36 PM
(This post was last modified: 11-11-2011, 09:37 PM by AlanBeckett.)
(11-11-2011, 07:51 PM)Retired Wrote: Getting the spindle out is another story ...........
That young Col is what's exercising my brain at the moment.
Attached are pictures of the Left and Right sides of the enclosures. Left and Right in this context are as viewed from the 'Control Panel' at the side of the set. The Trader Sheet implies that the panel on the Left can be removed. In the picture you can see the Tuning Capacitor hiding behind the Aerial Trimmer. However, the switch is on the other side. The panel on that side appears to be removable as well, although there'll be a job lot of wires to disconnect. Having gained access to the switch the question then is how to get it out as the shaft passes through a small hole in the centre partition. Do the contact fingers have to be removed in situ, and of course reassembled in situ later?
Come on Col, what do you remember?
Alan
Right1.JPG (Size: 2.73 MB / Downloads: 121)
