05-11-2011, 11:56 PM
The original finish will most likely have been cellulose lacquer applied by spray. Lacquer 'sits' on the veneer and adheres to it, rather than soaking into it, which is why, over time, lacquer will flake off. It looks to me from the pic as though the lacquer on the top has flaked off, revealing the bare veneer, and really, to do a proper job, it would be necessary to remove the rest of the lacquer with a cabinet scraper (not a paint scraper!). Veneer is very thin, so don't be tempted to use sandpaper, particularly on the bend, as you'll soon go through the veneer.
Having removed the lacquer, really, you have three choices, with varying degrees of difficulty. The easiest by far is to use Danish oil, which needs little skill, but unlike lacquer, the oil soaks into the veneer and cures as it dries, and a chemical change takes place. But that is irrevocable - once you've applied the oil, it can't later be removed as it's penetrated the timber. If you leave it to cure for 24 hours or so in a warm room. Apply several coats, leaving each coat to cure, then you can buff it with 00000 grade wire wool, and polish it with paste-wax polish, giving a very pleasing result. The ease of application ad pleasing end result explains why so many take this option.
The second option, having stripped the old lacquer off, would be to apply clear aerosol lacquer, which can be gloss or satin, and would be closer to the original finish. Finally, you could French polish it, and on the topic, the guru is without doubt, Colin - 'Retired', and Joe ('The Pil') has also done quite a bit of French polishing too. Both Colin and Joe have given much useful advice based on their own experiences. Cabinets were not originally French polished, so done properly, it's a considerable enhancement. Take a look at Colin's Bush radio in the gallery to see what can be achieved!!
Best of luck with it Steve,whatever course of action you take. (I guess you could always put a vase of flowers on top to cover it up!)
Having removed the lacquer, really, you have three choices, with varying degrees of difficulty. The easiest by far is to use Danish oil, which needs little skill, but unlike lacquer, the oil soaks into the veneer and cures as it dries, and a chemical change takes place. But that is irrevocable - once you've applied the oil, it can't later be removed as it's penetrated the timber. If you leave it to cure for 24 hours or so in a warm room. Apply several coats, leaving each coat to cure, then you can buff it with 00000 grade wire wool, and polish it with paste-wax polish, giving a very pleasing result. The ease of application ad pleasing end result explains why so many take this option.
The second option, having stripped the old lacquer off, would be to apply clear aerosol lacquer, which can be gloss or satin, and would be closer to the original finish. Finally, you could French polish it, and on the topic, the guru is without doubt, Colin - 'Retired', and Joe ('The Pil') has also done quite a bit of French polishing too. Both Colin and Joe have given much useful advice based on their own experiences. Cabinets were not originally French polished, so done properly, it's a considerable enhancement. Take a look at Colin's Bush radio in the gallery to see what can be achieved!!
Best of luck with it Steve,whatever course of action you take. (I guess you could always put a vase of flowers on top to cover it up!)
Regards, David.
BVWS Member.
G-QRP Club Member 1339.
'I'm in my own little world, but I'm happy, and they know me here'
BVWS Member.
G-QRP Club Member 1339.
'I'm in my own little world, but I'm happy, and they know me here'







