31-07-2011, 08:44 PM
Hi,
Do you have a drill press Jeremy as it would be easy enough to obtain a bit of 10mm dia bar stock and drill axially on centre at 6.5mm. If you need the sleeves to act as rollers I would suggest using brass rod.
Hope this is of use.
kind regards, col.
Do you have a drill press Jeremy as it would be easy enough to obtain a bit of 10mm dia bar stock and drill axially on centre at 6.5mm. If you need the sleeves to act as rollers I would suggest using brass rod.
Hope this is of use.
kind regards, col.
