18-11-2024, 12:48 PM
Hi
Yes I do have the washer and may have placed it in the wrong place?? I set it with the lock in piece to point 9 BUT it should have been at 10 (to cover 0 to 9 - 10 switch places). The hard part is that the base is still soldered (hard to move to reassemble) in and it's difficult to line up with no number markings.
Yes, the spring and balls had already shot out and I was lucky to find then inside the case of the valve tester.
Yes I do have the washer and may have placed it in the wrong place?? I set it with the lock in piece to point 9 BUT it should have been at 10 (to cover 0 to 9 - 10 switch places). The hard part is that the base is still soldered (hard to move to reassemble) in and it's difficult to line up with no number markings.
Yes, the spring and balls had already shot out and I was lucky to find then inside the case of the valve tester.
if all else fails...read the instructions!
