17-11-2024, 07:33 PM
I have not seen that one before but I imagine is follows usual practice.
Is there an end stop such that it will only rotate a certain number of positions? (some 12 way types will just keep rotating but when set to 10 way the contact may hit an end stop.
Is it possible to logically check a position at a time.
Sometimes it's a bit trial and error but obviously you only really want to clip it back together once.
Tracy
Is there an end stop such that it will only rotate a certain number of positions? (some 12 way types will just keep rotating but when set to 10 way the contact may hit an end stop.
Is it possible to logically check a position at a time.
Sometimes it's a bit trial and error but obviously you only really want to clip it back together once.
Tracy
