14-09-2016, 07:35 PM
(This post was last modified: 14-09-2016, 07:51 PM by Geordie McBoyne.)
I'm tasked to make a replacement motor board for a Garrard type "M" three speed record deck which will be used to replace the original EMI made 78 RPM only record player.
The third picture shows the furniture quality piece of plywood which will be used for the record deck.
Before I attempt to cut out the board for the record deck it is much wiser to use a piece of scrap plywood to determine the outline of the cut out for the Garrard deck.
This has been done, see the first and second attachments, so now it possible to cut out the board which is to be installed in the radiogram.
The original radio unit was deemed unserviceable and has been replaced be another EMI unit. A special panel has been made to suit the ersatz radio unit.
Geordie McBoyne.
The third picture shows the furniture quality piece of plywood which will be used for the record deck.
Before I attempt to cut out the board for the record deck it is much wiser to use a piece of scrap plywood to determine the outline of the cut out for the Garrard deck.
This has been done, see the first and second attachments, so now it possible to cut out the board which is to be installed in the radiogram.
The original radio unit was deemed unserviceable and has been replaced be another EMI unit. A special panel has been made to suit the ersatz radio unit.
Geordie McBoyne.
