15-03-2020, 01:31 PM
Further to my other post on this device, I am fortunate to have a PL50 screened probe with my VM77C. Unfortunately someone in the past has deemed it necessary to modify it by crimping on a croc clip on the ground pin (that's OK because it can just be pulled off) BUT they've soldered a wire to the thinner input pin and thus ruined the silver-plating and melted some of the plastic around the pin.
I'm not sure whether the PL50 had anything plugged onto it to make it usable in the real world; I note that a PL45 divider probe was available as an extra and was wondering whether this was a stand-alone part or itself was plugged onto the PL50? If anyone has any pictures or manual for these probes it would be useful to understand how they were intended to be used.
I'm not sure whether the PL50 had anything plugged onto it to make it usable in the real world; I note that a PL45 divider probe was available as an extra and was wondering whether this was a stand-alone part or itself was plugged onto the PL50? If anyone has any pictures or manual for these probes it would be useful to understand how they were intended to be used.