13-07-2020, 07:14 AM
Good morning all,
I wasn't my intention to cause any issues so please lets not push this one any further. I was only looking for something that would be smaller and could (should be!) used on a regular basis.
I've set up the T935a albeit it takes up the end of my workbench in the workshop. The workshop is only 12' x 6' 6'' and my workbench is my daughters old pine dressing table / desk which is quite narrow but usable. The challenge with older equipment is that it generally tends to be much bigger than modern day equipment so its striking a balance to what room is readily available for it to used.
Many thanks indeed for all your help and guidance. One thing I have decided on is to sell my old DM53 - its too big and too heavy!
Best Regards
Rob
I wasn't my intention to cause any issues so please lets not push this one any further. I was only looking for something that would be smaller and could (should be!) used on a regular basis.
I've set up the T935a albeit it takes up the end of my workbench in the workshop. The workshop is only 12' x 6' 6'' and my workbench is my daughters old pine dressing table / desk which is quite narrow but usable. The challenge with older equipment is that it generally tends to be much bigger than modern day equipment so its striking a balance to what room is readily available for it to used.
Many thanks indeed for all your help and guidance. One thing I have decided on is to sell my old DM53 - its too big and too heavy!
Best Regards
Rob
if all else fails...read the instructions!
