05-12-2019, 11:43 AM
Terry i wont be using that meter, its the extech im using. that photo was just to show that the unshrouded banana plugs wouldnt fit that particularly meter.
Also im unclear about no10. on the instructions for this bias probe " its says set the meter to the mv range (200mv) to get reading in Ma. SHould that be set the meter to the ma range to measure the plate current in ma.???
I`m assuming i would have to swtich the amp off and then set it up as the current uses a seperate input jack on the meter and i dont want to be unplugging the probe jack with power on???
Also im unclear about no10. on the instructions for this bias probe " its says set the meter to the mv range (200mv) to get reading in Ma. SHould that be set the meter to the ma range to measure the plate current in ma.???
I`m assuming i would have to swtich the amp off and then set it up as the current uses a seperate input jack on the meter and i dont want to be unplugging the probe jack with power on???
