Hi Lawrence
The close wound end which is on the left is connected to GB2, remember the lower half as seen in that photo has no winding on it as it is bridged by a curved brass plate.
Do you think the fact that the resistance wire was spaced widely contributed to its failure.
I have found this online and have emailed Blore Edwards to see if they can advise. https://media.wix.com/ugd/1636bd_6a64f4c...b51537.pdf
thanks
Mike
The close wound end which is on the left is connected to GB2, remember the lower half as seen in that photo has no winding on it as it is bridged by a curved brass plate.
Do you think the fact that the resistance wire was spaced widely contributed to its failure.
I have found this online and have emailed Blore Edwards to see if they can advise. https://media.wix.com/ugd/1636bd_6a64f4c...b51537.pdf
thanks
Mike
