22-05-2013, 07:22 PM
Good solution Rob, did similar with an Halli SX28, the shaft passed through many wafers and was about a foot long, I guess the upshot is not to rotate the shaft when withdrawing, not to rotate the wafers when replacing the components and not to rotate the shaft when re inserting, my case was similar as it was impossible to replace the components properly unless the shaft was removed.
I have a couple of caps to do on a R1155 which will entail band change switch shaft removal, not looking forward to it at all.
Lawrence.
I have a couple of caps to do on a R1155 which will entail band change switch shaft removal, not looking forward to it at all.
Lawrence.
