Hameg scope repair

[Yorkie]

David,
I meant to ask in my previous Post whether you have the other set of jaws for your chuck. Using that set for anything other than holding large diameter workpieces is a recipe for disaster. Sooner or later you'll run the tool into the jaws
Alan

Yes I do have the other set of jaws Alan - see attached pic, and you're quite right of course to have alerted me to the fact that I'd got the wrong jaws in. The last job I did was to turn the inside rims of a set of knobs for a Fenman1, which needed the jaws that I had in, but I should have fitted the other set of jaws, as illustrated below. Daft really - it's so obvious, so thanks for the timely reminder, and for keeping me on my toes!